2020-12-12

Side room electrical

Because of where the breaker panel is, I had the outlet circuit break off in the two directions to loop around the room.  Because of the added 14/3 wire for the switched outlet and supply for the closet light, I had to order a special extra large single gang box to comply with NEC box fill requirements.

All of the closets have at least 1 outlet, along with a CAT6 jack
Here's the switches, all the bedrooms are basically the same.  Light closest to the door, fan in the middle, and outlet(s) on the right.
Lots of wires going places in these... Each of these light boxes took me about half an hour to terminate.


at

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.

Subscribe to: Post Comments (Atom)

Rubber roofing

Finally time to actually start on the rubber roof.  That plastic I put down held up surprisingly well for how long it was there. Had to put ...

  • Replacing that bedroom window
    Now on to the window.  The city building inspector wants all of the windows to have headers, which means I have to reframe all of them, and ...
  • Finishing up the chimney
    I only took down the chimney below the roof line before, so now I had to get it down below the floor.  The first part that was above the cei...
  • Rubber roofing
    Finally time to actually start on the rubber roof.  That plastic I put down held up surprisingly well for how long it was there. Had to put ...